Downloaded from https://www.everyspec.com MIL-STD-31000A APPENDIX A A.3.2.7 Block 7. Associated list. This block is used to define the Government’s requirements for associated lists as defined in ASME Y14.34. A.3.2.7.1 Parts lists. Either “INTEGRAL” or “SEPARATE” or “CONTRACTOR SELECT” should be selected. This option requires the contractor to use either an integral or separate parts list for the specific item or part being documented. A.3.2.7.2 Data lists. Select “REQUIRED” if applicable. Data lists aid in assembling larger sets of drawings. Therefore, data lists should be required on most acquisitions of complex items.
When data lists are required, the contractor will be given guidance as to the levels of assembly at which they are required. For example, an electronic system composed of input and output sections made up of equipment racks containing replaceable drawers may require data lists at the drawer, rack, section and system (or end-item) level. Other terms for the required levels may be used. A.3.2.7.3 Index lists. Select “REQUIRED” if applicable. Index lists are not normally needed for small or moderate sized drawing packages of items that are not complex. However, they help in assembling the larger drawing packages required for major equipments, systems and subsystems.
The assembly level at which index lists are required should be specified. A.3.2.7.4 Wiring lists. Select “REQUIRED” if applicable. A wiring list is prepared to provide information necessary for making wire connections. A wire list may be prepared for one or more related assemblies. A.3.2.7.5 Application lists. Select either “INTEGRAL” or “SEPARATE” or “CONTRACTOR SELECT” if applicable. This option allows the contractor to provide either an integral or separate application list, if selected, for the specific item or part being documented. A.3.2.7.6 Other. This block is used to identify other Associated Lists that are required, but, not identified in A through E on the Worksheet.
Specify the requirement clearly in the block provided or in Block 9, Other Tailoring. A.3.2.8 Block 8. Applicability of Standards. This block is used to indicate the applicability of drawing and model standards. A.3.2.8 Block 9. Other tailoring. This block may be used to tailor any requirement of MIL- STD-31000, ASME Y14.100 with appropriate appendices, a DID, or any other document affecting the content, format, or media of the data product. In addition, if metadata or supplemental technical data was selected in Block 2, the specific type or content requirements should be identified in this block. 33