Downloaded from https://www.everyspec.com MIL-STD-31000B f. Sufficient metadata to establish ownership, identification and control, to include the following as a minimum: Nomenclature, Document/Drawing Number, Part Number, Contract Number, Design Activity Identification (e.g. CAGE Code(s)), Approved By, Approved Date, Revision Level Identification, Revision Date, and if applicable Export Control/ITAR Statements, Distribution Statements, Destruction Notices, and/or Classification Requirements,. g. Any non-graphical requirements that are needed to unambiguously define the part. 5.4.1.4 Commercial engineering design data and associated lists.
Commercial engineering design data and associated lists provide engineering and technical information in support of end products, or designated portions thereof, which are commercially developed items, commercial off-the- shelf items (COTS), or items not developed at Government expense. These data and lists shall be in accordance with the commercial design documentation practices of the contractor or supplier of the item. 5.4.1.4.1 Design disclosure. The degree of design disclosure on commercial engineering design data and associated lists, whether full design disclosure or limited design disclosure, shall be as stated in the contract for each TDP element. 5.4.1.4.2 Data rights.
Rights in data for commercial engineering design data and associated list shall be as stated in the contract for each TDP element. 5.4.2 Special Inspection Equipment (SIE) engineering design data and associated lists. SIE engineering design data and associated lists shall be prepared to provide the data required to manufacture or assemble SIE, which is mandatory to successfully produce the item. The SIE shall be defined in detail to the extent necessary for a competent manufacturer to manufacture or assemble SIE, which duplicates the performance characteristics of the original SIE. SIE is also known as special test equipment.
5.4.3 Special tooling engineering design data and associated lists. Special tooling engineering design data and associated lists shall be prepared to provide the data required to manufacture special tooling which is mandatory to successfully produce the item. The special tooling shall be defined in detail to the extent necessary for a competent manufacturer to produce tooling which duplicates the performance characteristics of the original tooling. 5.4.4 Specifications. Specifications shall be prepared as performance specifications or detail specifications as required in the contract. 5.4.4.1 Defense specifications.
Defense specifications shall be prepared in accordance with MIL-STD-961 as coordinated, limited or interim specifications. 5.4.4.2 Program-unique specifications. Program-unique specifications shall be prepared in accordance with MIL-STD-961 as item, material, process, software, or system specifications. 5.4.4.3 Commercial Item Descriptions (CIDs). CIDs shall be prepared in accordance with the Federal Standardization Manual to describe, by functional, performance, or essential physical requirements, available commercial products or services. 5.4.5 Software documentation. Software / Firmware documentation a.
Documentation for software CIs defined in the TDP shall be prepared in accordance with 17