MIL-STD MIL-STD-810B Method 513.1 / 514.1 — MIL-STD-810B Method 513.1 Acceleration & 514.1 Vibration Test Standard PDF

Downloaded from https://www.everyspec.com MIL-sTD:eioB ~-. 4.14.2.3 15 June~196~ . Step 1 - Secure the test item to the vehicular, or slmmlated,‘adapter Performanceof test. - plate in accordancewith section 3, Oeneral Requirements, paragraph 3,2,2, end place on the package tester.with the constraints outlined in 4.14.2.2(b). If the test iteniweighs over 200 pounds, an approved simulated adapterplate shall be used. Step 2 - Attach an accelerometeras close as possible ta the point of test item attachmentto record the shock transmittedto the test item.

Step 3 - Adjust the package tester, shafts in phase and table operating in a vertical linear mode, to a speed such that the average value of the rendom accelerationpeaks shall be 7.5 +/-2.5 g’s, Measure this input with an accurate measuring or recording system at the output of a band pass filter. The filter band pass shall be 0.2 to 100 cps and the attenuationslope shall be 12 to. 18 dB ‘peroctave at the 3-dB down point. Oue,to the random nature of the input, pulses greater than cen be expected to occur, however, if they are infrequent,they need not be used in calculating the average, Perform the test for a total of 3 hours.

At the end of each 3/b-hourperiod, rotate the adapter plate end test item 90 degrees each time in tbe . same direction. Step ~ - At the end of the 3-hour period, operate the test item and compare the resultswith the data obtained in accordance with section 3, oeneral Requirements,paragraph 3.2.1. Then inspect the test item as specified in section 3, General Requirements, paragraph 3.2.4. 4.15 Procedure X. - Proceed the smne as in b.5.l.1, &.5.l.2, and L.5.1.3. The test level shall be according to specified cwe( S) AV, AW, AX, AY, AA and AQ from figure 51b.1-7 as applicable. Test tire?schedules shall be as specifiedfor Procedure X as shown in table 51k.1-VII.

When test item resonancesbelow 5 cps are measured or expected the test curves shall be extended to 2 cps. .. )!.16 prOced~re XI. - .. k.16.1 ~. - Proceed the same aS in part.1 of Rocedure IX. ....=. ... b.16.2 part 2, bounce, loose cargo. - 11.16.2.1 Purpose.- To determin+ that the equipment, as prepared for field use, shall be capable of withstmding the vibrations nom inducsd during trdnsportaticm ae190Le cargo. Equipment in this class is normally transported in a shipping case, transit case, or combination case. 514.1:11 - METSOD. 514.1 - ~ 20 Octob-e>“1969 (- i I I .. .,.’..’,. .!. ,., i