Downloaded from https://www.everyspec.com MTL-STB81OB 15 June 1967 .- ,/’- 1, h.18,2.l Purpose. - To insure that the system shelter assemblageshall be capable of withstanding the vibrationsnormally induced during transportation. The system shelter assemblage may consist of equipment mounted in a truck or trailer, or equip- ment mounted in a shelterwhich is then mounted on a truck or trailer. 4.18.2.2 Performanceof test. - The system shelterassemblage shall be driven five tim+s over tbe sections of the Munson Test Course,atthe Aberdeen Proving Ground, Aberdeen, Maryland, or approved equal, in the followingorder and at the specified speeds.
(See 4.1.) Coarse whboard (6-inch waves spaced 72 inches apart) 5 mph Belgian block 20 mph Radial washboard (2-inchto b-inch waves) 15 mph Single corrugations (h-inch to 6-inch waves) 20 mph Any short sections between the above sections 20 mph 5. summary.- The following details shall be specifiedin the equipment specifi- cation or test plan: (a) Procedure number (see 3). (b) Pretest data required (section 3, Oeneral Requirements,paragraph 3.2.1). (c) Curve selection (see 3.3). (d) Accelerationor frequency aerating of selectedcurve, if required (see 4.5.1). (e) Nonoperationof equipment during test, if desired (see b.1). (f) Limitation of trmsverse motion (see 4).
(g) ‘Temperaturextremes ad test time durations (see k.3). (h) ~~e~ur~ for combining sinusoidal and random vibration, if,applicable . . (i) Total vehicle mileage (see table 514.1-VI). (,I) Total land tre-mportationmileage”(see tiu schedtie in table 514.1-VII). . 514.1-13 MSTSOD 514.1 20 October 1969