MIL-STD MIL-STD-810B Method 513.1 / 514.1 — MIL-STD-810B Method 513.1 Acceleration & 514.1 Vibration Test Standard PDF

.. ’,.,., MII?%W81OB :-’:,. 15 We, 1967: = -.. . . . ,. . . . ,.:-.,:’:, . . :. Downloaded from https://www.everyspec.com 3.l! FrocedureI. - - .,.-..-_: The test item should be softly suspended in tbe ... test chamber bf means of ‘springsor elastic cord. If a mounting structure is required betweenthe soft suspension and the test item or to hold the soft suspen- sion care must be exercised to assure that no spurious acousticor:vibratory inputs are introduced. The natural frequency of suspensionshall be less than 25 cps. ‘Ihetest item shall be exposed on every surfaceto the so~d field”by centrally ‘locatingit in the test chamber. The test item volume shouldbe no more than 10 .. .. ..

.......... ... ,.-.:. .... ....: .. . . .- -., 3.4.1 Test item mounting. - percent of the test chauber volume: When the test chamber is rectan@ar, no maJor .. . surface of the test item shall be installed parallel to a cheziberwall. .. 3.4.2 Per~orme.nceof test. - Step 1 - The overall sound pressure level for the specified test cate’goryof table 515.1-1 shall be introducedinto the test chamber to conform with the octave band spectmm specified on figure 515.1-1 or 515.1-2 l_/. The average sound pressure distributian (overall level) should be unifcpn within -2 to +h dB of the desiredvalue. The . sound pressure field shall be measured without the test item mounted in the test chamber.

Measurementsshall be made by using a microphone (more than mie if desired) to define the sound field within the test volume (central 10 percent of the chamber volume). ~ Choice of ~igure 515.1-1 or 515.2-2 i 5 dependent on test equipment availability. ~-- Step 2 - The test item shall be placed in the chamberas sp-ecified in 3.4.1. At least three microphones shall be umnitored. They shell be located in proximity to each major dissimilar test item surface, at least 18 inches fram the test item surface or one-half the distance to the nearest chember wall, whichever is less.

The average overall sound pressure distributinn emound the test item shall be measured and be uniferm within -2 to +4 dB of the desiredvalue. However, for large a irregularly shaped items where this tolerence cannot be achieved, the tolerance shall be 26 dB. Test times shall be as specified in table 515.1-1. The operation of the test item during the test shall be monitoredwhen and as apecified. Following the test and when measurements are made during or folloving the test, they shall be compared with the data obtained in accordance with section 3, General Reqwiiments,parag?apb 3.2.1.

At the conclusionof the test, the test item shall be inspected in accordancewith section 3, General Requirements; paragraph 3.2.~. . . 75=-2., ... ,., . . ,4 . ~ . ; ., . 515.1:3 .: c. . ,., ,.. .,. ::,... ,., , , .,:, ,.. ,, 1 .. . . . .. . . . . ,, . : .., .. - . ,,, - ., .’....... . ..”