MIL-STD MIL-STD-810B Method 513.1 / 514.1 — MIL-STD-810B Method 513.1 Acceleration & 514.1 Vibration Test Standard PDF

.. . . . . MIL-sql-810B- 15 Jtii 1967 ~ 3.8.2 Performanceof test. ( Downloaded from https://www.everyspec.com ~, (a) TWO cars will act”as buffer CMS and be located on a level section of track. The air brakes shall be set in the emergency application position on both care. The total buffer load excluding car weights shall be 140,000 pounds minimum. (b) The test item shall be mounted Oritbe end of the test car in direct contactwith the floor and adquately blocked and secured to prevent any longitudinal,vertical, or lateral movement. Metal banding, or wire, cf sufficient size or strength shall be used to provide 6ddi- tional tiedown strength.

Positions of the equipment with respect to the test car and whether or not packaging is necessary shall be specified. If loading s,* tie-down3 are not specified,all lGading and tie-downs shall be in accordance with recommendedpracticea af the Association of American Railroads. (c) Impact the test car into the two loaded cars. (d) Impact shall be made in progressive step.with impacts 8, 9, and 10 miles per hour. The speed Just prior to impact shall be measured by electroni:cr electrical means. 3.9 Related shock tests. - 3.9.1 Missile latinchor missile impact.

- A test for simulatingmissile launch, missile impact, hard landings,etc., may be performed by employing a rccket sled test facility,cmnpressed gas ram,cr other high accelerationapparatus suitable for per- forming the required te3t. 3.9.2 Hardsites. - Equipment located in or at missile hardsites usually demands special testa, however, for some zones, special adaptationsof conventionalshock machines may be used. For the critical zones, shock tubes, explosion chambers, hydraulic actuators, etc., can be used. 3.9.3 High impact. - Unless othez-fisespecified,ballistic shock,tests and high imp.ct tests shall be performed in accordance with MIL-S-901.

3.9.& Shipboard equipment.- Shock tests for shipboardequipment shall be performed in accordancewith MIL-S-901. ~.. . 3.9.5 Rough hendling for packaged items. - Tests for shipping and handling shall be performed in accordancewith KIVP-116 or FEDERAL STII.NO. 101. METSOD 516.1 20 October 1969 516.1-6,:, . .. ... . ., . . .. . .,. . ..... . . .; - (.