EPSON — Printing

Appendix 321 No. Name Description 19 Bidirectional Printing If you unselect this check box, one-directional printing is selected, and printing is performed only when the print head moves in a certain direction. The print quality is improved, but print speed falls below normal. If ruled lines are misaligned or unevenness occurs, selecting one-directional printing may improve the symptoms. Setting value: -2.0 to 2.0 20 Belt Feed Adjustment Adjusts the belt feed amount. Setting value: -10 to 10 21 Belt Flushing Sets flushing. Select this check box to enable this setting. This is disabled if Cut Sheet Mode is selected.

If Belt Flushing is enabled, automatic nozzle checking is not performed during printing. If you want to perform an automatic nozzle check while printing with Belt Flushing enabled, pause printing and press the [Maintenance] menu - [Auto Nozzle Check] tab - [Start]. For more information on pausing printing, refer to "Emergency Stop and Pause" on Page 20. 22 Margin (Home) Sets the margin for flushing on the home side. Select this check box to enable this setting. This is disabled if Belt Flushing is not selected. 23 Margin (Full) Sets the margin for flushing on the full side. Select this check box to enable this setting. This is disabled if Belt Flushing is not selected.

24 Print Operations Configures the settings for when printing automatically. 25 Auto Pause Sets the machine to pause after the specified length has been printed. Select this check box to enable this setting. 26 Printing Length (Auto Pause) Sets the length for the machine to pause after the specified length has been printed. Setting value: 0.1 to 999.9 m 27 Auto Cleaning Sets the machine to perform cleaning after the specified length has been printed. Select this check box to enable this setting. 28 Printing Length (Auto Cleaning) Sets the length for the machine to perform cleaning after the specified length has been printed. Setting value:

0.1 to 999.9 m 29 Level Sets the strength for the machine to perform cleaning after the specified length has been printed. Adjust the Level setting as necessary.