MultiPlus-II 2x120V Recommendation: Turn WeakAC on if the charger is hardly charging or not charging at all (which is quite rare!). Also turn on the dynamic current limiter simultaneously, and reduce the maximum charging current to prevent overloading the generator if necessary. When WeakAC is on, the maximum charge current is reduced by approximately 20%. BoostFactor Change this setting only after consulting with Victron Energy or with an engineer trained by Victron Energy! Programmable relay The relay can be programmed for all kinds of other applications, for example as a starter relay for a generator.
Auxiliary AC output (AC-out-2) Intended for non-critical loads and directly connected to the AC input. With current measurement circuit to enable PowerAssist. 5.3. Configuring The following hardware is required: A MK3-USB (VE.Bus to USB) interface. RJ45 UTP cable 5.3.1. VictronConnect app The MultiPlus is configured using the VictronConnect app. More general information about the VictonConnect app, like how to install it, how to pair it with your device, and how to update firmware, can be found by referring to the overall VictronConnect manual . 5.3.2.
VEConfigure All settings can be changed with a PC and free of charge software VEConfigure, downloadable from our website www.victronenergy.com . See the VEConfigure manual for more information. 5.3.3. VE.Bus Quick Configure Setup VE.Bus Quick Configure Setup is a software program with which systems with a maximum of three inverters/chargers can be configured in parallel or three-phase in a simple manner. The software can be downloaded free of charge at www.victronenergy.com. 5.3.4. VE.Bus System Configurator For configuring advanced applications and/or systems with four or more Multis, VE.Bus System Configurator software must be used.
The software can be downloaded free of charge at www.victronenergy.com. Page 19 Configuration