en Before using the appliance 5.1 Preparing the base unit 3. Insert the required perforated disc into the housing. → Fig. 8 Observe the recess on the perfor- ated disc. 4. Fit the threaded ring and tighten Note: The food processor shown in the pictures may differ from your model in terms of shape and fea- tures. 1. Set up the base unit as described in the main operating instructions. 2. Press the release button and move clockwise slightly. → Fig. 9 Assembling the juicer attachment 1 the swivel arm down until it en- gages in the vertical position. → Fig. 3 a The swivel arm is fixed in posi- Follow the illustrated instructions. → Fig. 10 - 14 Assembling the Viennese whirl attachment 1 tion 3.
3. Rotate the base unit to the operat- ing position. → Fig. 4 Follow the illustrated instructions. → Fig. 15 - 18 5.2 Inserting the seal Assembling the grater attachment 1 ▶ Insert the seal into the housing Follow the illustrated instructions. → Fig. 19 - 22 and press in firmly. → Fig. 5 The recesses must match up ex- actly. 5.4 Fitting the attachment 5.3 Assembling the attach- 1. Open the locking lever. → Fig. 23 2. Hold the prepared attachment hori- ments Note: To use the special accessory, you need the parts of the meat min- cer, except for the knife and perfor- ated disc. zontally and match up the ends of the agitator paddle with the drive. → Fig. 24 3.
Push the attachment fully onto the drive. 4. Rotate the attachment anticlock- Assembling the meat mincer 1. Fit the worm gear into the housing wise as far as possible. → Fig. 25 5. Close the locking lever. with the agitator paddle at the front. → Fig. 6 2. Fit the knife onto the worm gear → Fig. 26 6. Tighten the threaded ring clock- with the square projection at the front. → Fig. 7 wise. 7. Attach the filling tray. → Fig. 27 8. Place a suitable container under the attachment. → Fig. 28 1 Special accessory 12