3 System Setting Mode 3-2 Functions of System Setting Mode 3-2 Functions of System Setting Mode The following items can be set in System Setting Mode: (1) Time calibration: check whether the year, month, day, hour, minute and second are the current time values, and if not, rectify them manually. (2) IP Address (Only supported by NB -TW01B): Sets the IP address for PT. Port (Only supported by NB -TW01B): Sets the port number. Subnet Mask (Only supported by NB -TW01B): Sets the subnet mask. (3) Startup Window No.: the window displayed after launching the NB Unit. The default is window 0. Gateway (Only supported by NB -TW01B): Sets the gateway. (4) Backlight Saver Time:
time to activate the screen saver, and the Unit is minute. The default is 10 minutes. The screen saver is not brought into effect when the set value is 0. (5) Mute Enabled/Disabled: ON/OFF of the buzzer. (6) Brightness Up/Down: with this, brightness of the screen can be adjusted, bringing the screen to its best visual effect. (7) Export/Import (Only supported by NB -TW01B): USB PT: Uploads the user project file (.pkg) required by the PT operation to the USB memory. And the upload password is required during the export. If the upload password is not set, it needs to use the default password of 888888. USB PT: Downloads the user project file (.pkg) in USB memory to PT. RCP PT:
Uploads the recipe data file (.rcp) in PT to the USB memory. RCP PT: Downloads the recipe data file (.rcp) in USB memory to PT. (8) Enable Printer Function: refer to Section 7 Pictbridge Printing in NB-Designer Operation Manual for details. The System Setting Mode screen of the NB7W-TW01B is as follows: NB-series Programmable Terminals Setup Manual(V107) 3-3 3