Nucleo GX Manual In the GX device menu, go to Settings → Integrations → Modbus Devices → Discovered devices and enable the discovered energy meter; it's disabled by default when first installed and powered. The VM-3P75CT then becomes visible in the device list and can be monitored from there. For more details, see the energy meter manual . 5.11. EV Charging Station The EV Charging Station and EV Charging Station NS , with both three-phase and single-phase charging capabilities, integrate seamlessly into the Victron environment via a GX device connection over WiFi. Operation and monitoring are easily managed via Bluetooth using the VictronConnect App .
Set up and configure the EVCS according to the instructions in the EV Charging Station manual . Ensure that: 1. Communication with the GX device is enabled. 2. The EVCS and GX device are connected to the same local network. GX device setup Page 29 Connecting Victron products 1. On the GX device, navigate to: Settings → Integrations → Modbus TCP Server, and enable Modbus TCP Server. 2. Then go to: Settings → Integrations → Modbus Devices → Discovered devices, and enable the detected EVCS. Note: EV Charging Stations connected before updating the GX device to firmware version 3.12 will be activated automatically. New devices must be enabled manually via the above menu.
Once activated, the EVCS will appear in the device list, where it can be monitored and controlled. For further details, refer to the EV Charging Station Manual. Control of the EVCS is also available from the control pane by tapping the control pane button in the top left corner of the user interface.