Nucleo GX Manual 7.6. Multiple network connections (failover) GX devices support concurrent connections to multiple network interfaces: Ethernet, WiFi, and LTE (via the GX LTE 4G accessory). Interface priority for internet access When more than one interface is available, the GX device will automatically prioritise them in the following order: 1. Ethernet; always preferred, regardless of WiFi or LTE availability 2. WiFi; used if Ethernet is unavailable, regardless of LTE availability 3. LTE; used only if both Ethernet and WiFi are unavailable Internet access via Ethernet and WiFi GX devices can be connected to both Ethernet and WiFi at the same time.
Note that this setting does not apply to the LTE interface. Each interface has an option to control whether it may be used for internet access, regardless of whether IP configuration is set to Automatic (DHCP) or Manual. Enable the option on the interface that should provide internet access. If the option is disabled, the interface remains available for local network communication, but it will not be used for internet traffic. When this option is disabled, the Gateway field is hidden in the interface settings for that connection. Technically, disabling the option removes the default gateway from that interface.
Without a default route, the interface can only communicate within its local subnet and cannot access the internet. Connection priority is based solely on network interface availability, not on whether the connection provides actual internet access. The device does not verify connectivity to the internet when selecting an interface. Page 73 Internet connectivity • Settings → Connectivity → Ethernet → Allow using Ethernet for internet access • Settings → Connectivity → WiFi → Allow using WiFi for internet access If WiFi is your only active internet connection, disabling this option will disconnect the GX device from the internet and VRM.
Before the setting takes effect, a warning dialog is shown asking you to confirm. If Ethernet is also connected and active, VRM connectivity will be maintained. If disabled unintentionally on a remote system without Ethernet, physical access may be required to restore internet connectivity.