Victron Nucleo GX — 8.2. Accessing via built-in WiFi Access Point

Nucleo GX Manual 8.2. Accessing via built-in WiFi Access Point This method requires the VictronConnect app to be installed on your smartphone, tablet, or laptop. Steps to connect automatically via the QR Code: 1. Locate the QR code sticker on the side of the NGX 2. Scan the QR code using your phone's camera function, or a QR code scanning app 3. If supported by your phone, this will prompt you to connect you to the WiFi Access point 4. Once connected, open VictronConnect 5. Select the GX device from the list 6. Open the Remote Console Steps to manually connect: 1. Stand close to the Nucleo GX, no further than a few meters away. 2. Open the WiFi settings on your phone, tablet, or laptop. 3.

Look for a network name like Venus-[serial_number-xxx]. 4. Connect using the WiFi key, printed both on the side of the box and on a card included in the plastic bag. Keep this key stored securely. 5. Launch VictronConnect, which will start scanning the WiFi network automatically. 6. Once found, select the GX device from the list. 7. Open the Remote Console Notes If you cannot use VictronConnect, you can use a web browser and navigate to the IP address http://172.24.24.1 or http:// venus.local For additional security, the WiFi Access Point can be disabled: Navigate to Settings → Connectivity → Wi-Fi → Create access point in the Remote Console.

Instruction video Watch the step-by-step instruction video on how to connect to a GX device using the VictronConnect app: Page 77 Accessing the GX device