Safety functions Maximum velocity Furthermore there is the possibility to define the maximum allowed travel velocity of an axis in the axis parameters or to limit the output of the drive in percent (see TwinCAT System Manager Documentation > NC - Configuration > Settings Dialog > Axes - Dialog: Global ). For example, it can happen that, by mistake, the direction of actuation of the axis control loop (positive feedback) is altered as a result of changeover of drive or encoder polarity, and the axis, with full logical consistency, drives towards the mechanical end position at maximum output value. In the following situations the maximum velocity can be exceeded:
Through position compensation of the master or slave axes. Through setting or changing the coupling factor of a slave axis or (indirectly) of the flying saw. Through externally generated data in the FIFO or the table slave axes. Stop All master axes can be stopped at any time. Notice The flying saw is the only slave axis that has a stop function. However, there are situations when a flying saw cannot be stopped. Slave axes are to be stopped by converting them online into master axes, which can then be stopped. The FIFO axes can be stopped and the NCI group can be stopped.
Hardware monitoring It may be that a facility in an emergency situation (emergency stop, watchdog, etc.) must not be allowed under any circumstances, for mechanical or other reasons, to halt abruptly its axes in the next I/O cycle (e.g. to command 0 V suddenly). Such behavior can only be ensured via the drive hardware that is present. To this end most manufacturers offer simple digital circuitry options that ensure that an axis is brought to a halt in a defined way (braking ramp, standstill window for electrical deactivation of the control system and activation of the brakes, etc.). Numerical Control (NC) Basics 11 Version: 1.2