beckhoff TwinCAT 2 — 4.4 "Low Cost" stepper motor axes with digital control (24V / 2A)

TwinCAT NC Axes Stepper motor parameters of the drive Depending on the type and operating mode of the stepper motor, up to 8 byte masks for the drive output pattern can be parameterized in the "stepper motor" drive tab of the System Manager. Depending on the operating mode of the axis, these patterns are cyclically output during active positioning and are repeated periodically. With the axis at standstill (no active travel), the last bit pattern to be output is linked to the holding current mask as a logical AND operation. This holding current mask is intended to reduce the motor current and therefore the motor temperature of the axis at standstill.

Example of velocity and position profile The graph shows a typical velocity and position profile for a 'low cost' stepper motor axis vs. time [s]. The blue curve shows the velocity [mm/s], and the green curve the position [mm]. The set values and actual values are identical, because a simulation encoder was used, not a real encoder. The discrete velocity levels are noteworthy. Their value, starting from the start velocity, rises to the required set velocity, and falls again to the stop level towards the end of the target position. Numerical Control (NC) Basics 30 Version: 1.2