NJ Configuration 1. In Sysmac Studio, configure the Sysmac NJ tags as shown in the Global Variables. 2. Synchronize the project with the NJ controller to transfer the Tags to the NJ. 3. In Sysmac Studio, export the Tags to the Network Configurator for EtherNet/IP. 4. Save the .csv file that contains the tags. This will be imported in a later step. 5. In the Network Configurator for EtherNet/IP, add an NJ to the network diagram. Select the correct model and Revision. Rev 1 = NJ firmware 1.00, 1.01, or 1.02. Rev 2 = NJ firmware 1.03 or higher. QSG-NX-S-STANDALONE - Version 3.2 Feb. 27, 2015 Page 27 OMRON AUTOMATION & SAFETY • © 2015 Omron Electronics LLC • www.omron247.com