omron — A-1-6 Installation and Wiring

Appendices A-1 Designing Example of the Safety Functions for the Pick-and-place Equip- ment A A-1-6 Installation and Wiring A-1-6 Installation and Wiring This section describes the installation and wiring related to the safety functions for the pick-and-place equipment. The NX Unit configuration of the EtherNet/IP Slave Terminal and the wiring diagram of the safety devi- ces are described in this guide. Refer to the following manual for details on installing and wiring the actual devices. • NX-series Safety Control Unit User’s Manual (Cat. No. Z930) • NX-series EtherNet/IP Coupler Unit User’s Manual (Cat. No. W536) • eCobra 600 and 800 Robot with EtherCAT User’s Guide (Cat. No.

I653) • T20 Pendant User's Guide (Cat. No. I601) Compose the EtherNet/IP Slave Terminal by the connection order shown in the figure below. A-7 NJ-series Robot Integrated System Startup Guide (O049) Name Model Manufac- turer Description EtherNet/IP Coupler Unit NX-EIC202 OMRON A Coupler Unit that supports EtherNet/IP. This Unit can compose a Slave Terminal by connecting with an NX Unit. Safety CPU Unit NX-SL3300 OMRON A Unit that runs safety programs. Safety Input Unit NX-SIH400 OMRON A Unit to be connected with safety input devices. Safety Output Unit NX-SOD400 OMRON A Unit to be connected with safety output devices. Safety Light Curtain F3SG OMRON A photoelectric safety sensor.

This sensor detects human entry to hazardous area. Safety Door Switch D40A OMRON A non-contact safety door switch. This switch detects open and close of the entrance door to hazardous area. Reset Switch A22-H £-10M OMRON A reset switch. This switch is used to manually recover the equipment from the stop state after the safety function oper- ated. Emergency Stop Pushbutton Switch A22E OMRON An emergency stop switch. Safety Relay G7SA OMRON A safety relay. Unit Power Supply S8VK OMRON A 24 VDC power supply. This control power supply is for the EtherNet/IP Coupler Units and the NX Units. I/O Power Supply S8VK OMRON A 24 VDC power supply.

This power supply is for the I/O cir- cuits of the NX Units and the connected external devices. NX Unit Configuration