Making Connections Using OmniBook Plug-In Modules To replace a plug-in accessory module 1. Important : If you are removing or inserting a CD-ROM drive or Zip drive, shut down the OmniBook before removing or inserting the plug-in module.(From the Start menu, shut down Windows 95.) This is not necessary if you are removing and installing the floppy disk drive or secondary battery. 2. Slide the safety latch for the plug-in slot into its recess. 3. Slide and hold the release latch, then pull out the module, as shown. Safety latch Release latch 4. Insert the new plug-in module. 5. Close the safety latch. C A U T I O N If inserting another plug-in module, be sure the safety latch is open.
Otherwise you could damage the module or your OmniBook. 5-4