Setting a Password If password protection is set, then you will be prompted to enter a password whenever you reset or turn on the computer (depending on your setting). You cannot use the computer until you enter the correct password. To set, change, or delete password protection for this OmniBook, you must use the BIOS Setup utility. This program is described fully in the Reference Guide that came with your OmniBook. To set or change a password 1. Reset the computer and press F2, when prompted, to enter the BIOS Setup utility. Active keys are described along the bottom of the screen. (The TouchPad does not work in BIOS Setup.) 2. Select the Security menu. 3.
Select Set System Password, press ENTER, and follow the directions. The password can contain up to eight alphanumeric characters, and it is not case- sensitive. 4. Determine when the password will be required: select Password on Boot and, if desired, Password on Resume, and press F5 to select Enabled or Disabled for each one. 5. Press F10 to save and exit the BIOS Setup utility. Caution Be sure you record your password in a safe place. To restore operation if you forget your password, you will need to return your OmniBook computer to Hewlett-Packard for repair. You will also need your proof-of-purchase. Call Hewlett-Packard at the number in the Support and Service booklet.
To clear a password • Follow the above instructions. When prompted to set the password, press ENTER twice and continue. 27