Expanding the OmniBook Replacing Internal Hardware 5. Important: Disengage the hard drive connectors by grasping the left flap of the plastic insulator and pulling to the right as shown. 6. CAUTION: Handle the hard drive only by its edges to avoid damage from electrostatic discharge . Lift up on the left flap of the insulator sheet and remove the hard drive. The insulator sheet stays in place. 7. Important: If your new hard drive is from a different manufacturer than the old one, it may have screws in different positions. Determine which mounting holes you need; then, if necessary, push out rubber screw-hole covers from the inside using a bent paper clip.
(From the outside of the computer, insert the rubber covers into the holes you won’t need.) 3-5