Chapter 3: System Installation 3.4 Adept Hornet 565 Robot User's Guide, User’s Guide, Rev A Page 44 of 142 Step Connection Part 4 Connect T20 adapter cable to eAIB XSYSTEM cable XMCP connector or J, K 4a if no T20, install XMCP jumper or T20 Adapter Cable with T20 bypass plug. G or H 5 Connect user-supplied ground to robot. See Grounding the Adept Robot System on page 52. n/a 6 Connect 200-240 VAC to AC Input on eAIB Interface Panel; secure with clamp. L 7 Connect 24 VDC to DC Input on Interface Panel. N, M 8 Connect Ethernet cable from PC to eAIB. P 10 Connect optional eAIB XBELTIO cable to the XBELTIO port on eAIB.
U 11 Connect the Y-adapter cable to the eAIB XBELTIO cable, Belt branch V ept ACE Software er-supplied PC The user loads the Adept ACE software onto the PC and connects it to the eAIB via an Ethernet cable. Depending on the other equipment in the system, there may be an Ethernet switch between the two. stalling Adept ACE Software The Adept ACE disk will display a ReadMe file when inserted in your PC. This contains hardware and software requirements for running Adept ACE software. You install Adept ACE from the Adept Software disk. Adept ACE needs Microsoft .NET Framework. The Adept ACE Setup Wizard scans your PC for .NET, and installs it automatically if it is not already installed. 1.
Insert the disk into the disk drive of your PC. If Autoplay is enabled, the Adept software disk menu is displayed. If Autoplay is disabled, you will need to manually start the disk. NOTE: The online document that describes the installation process opens in the background when you select one of software installation steps below. 2. Especially if you are upgrading your Adept ACE software installation: from the Adept ACE software disk menu, click Read Important Information. 3. From the Adept ACE software disk menu, select: Install the Adept ACE Software The Adept ACE Setup wizard opens. 4. Follow the online instructions as you step through the installation process. 5.
When the installation is complete, click Finish.