Orion-Tr Smart DC-DC Charger Isolated 4.5. Connection setup for DC-DC power supply mode 1. Disconnect the remote on/off; remove the wire bridge or unplug the terminal block. 2. Connect the input supply cables. 3. Open the VictronConnect App to set up the product, see Power Supply Mode [29] (always adjust the output voltage before connecting in parallel or connecting a battery) . 4. Connect the load. The Orion is now ready for use as a power supply. 5. Reconnect the remote on/off to activate the product. Figure 1: Typical connection setup as DC-DC power supply 4.6. Connection setup for charger mode 1. Disconnect the remote on/off; remove the wire bridge or unplug the terminal block. 2.
Connect the input supply cables. 3. Open the VictronConnect App to set up the product, see Charger Mode [30] (always set up the correct charger algorithm before connecting a battery) . 4. Connect the battery to be charged. 5. Reconnect the remote on/off to activate the product. Figure 2: Typical connection setup as charger Page 7 Installation