Orion-Tr Smart DC-DC Charger Non-Isolated In a vehicle where the alternator is switched off for long periods and the base load is low, fine-tuning may not be enough to keep charging going. An external engine running signal can be used instead; see the Using an external engine running signal [13] section. 5.4. Using an external engine running signal The engine shutdown detection determines whether the engine is running from the input voltage. In some vehicles the alternator voltage does not follow the engine, for example when a smart alternator is switched off for long periods while driving. In such an installation, a signal from the vehicle can be used to tell the that the engine is running.
Such a signal is connected to the remote L-pin. While the signal is present, it overrides the engine shutdown detection and charging is forced on. While the signal is absent, the returns to the engine shutdown detection, which decides whether the engine has stopped. For the wiring, see the External engine running signal wiring [9] section. Leave the engine shutdown detection enabled in the VictronConnect App when an external engine running signal is used. The signal only forces charging on; stopping charging when the engine is off remains the task of the engine shutdown detection.
When the engine shutdown detection has been switched off in the VictronConnect App ('forced charging'), current will be drawn from the starter battery even if the engine is not running , regardless of any external signal that is connected. The input voltage lock-out is then the only limit left to disable charging automatically; make sure this level is not set too low — in most 12V systems 12.5V is sufficiently low. Which signal to use Several sources can provide an external signal. Each has its drawbacks, which should be understood before choosing one. Vehicle engine running signal:
This is the most accurate source, as the signal comes from the vehicle's own system and follows the engine directly. However, accessing this signal can be challenging, and it may require activating the function in the vehicle's software. Pulled-low engine running signal: Some vehicles provide an engine running signal that is pulled to ground (battery minus) while the engine is running. This is the opposite of what the L-pin expects, so the signal cannot be connected to the L-pin directly. A relay is used to convert it; see the External engine running signal wiring [9] section. D+: The D+ signal, which comes from the alternator, indicates that the alternator is active.
In Euro 6 vehicles this signal is often no longer provided, making it unusable. There are D+ simulator devices that generate a signal based on the alternator voltage, but these work from the same voltage that the engine shutdown detection already measures, so in an installation where the alternator voltage is the problem they offer no advantage. Ignition switch: It is common to use the ignition switch to enable charging. While this method is not inherently wrong, it allows the to discharge the starter battery when the ignition is on but the engine is not running. This requires the user to be vigilant about when charging is permitted, to avoid a flat starter battery.
Therefore, we do not recommend using the ignition switch to enable charging. Vibration sensor: This device generates a voltage when it detects engine vibrations. Be aware that external vibrations, such as those from transport on a boat or train, or even loud music, can be mistaken for a running engine. To mitigate this, power the vibration sensor from an ignition-switched source, so that charging is only permitted when both the ignition is on and vibrations are detected. CAN bus interface with engine running output: This device reads the engine running command broadcast on the CAN bus and converts it into an on/off signal.
This requires tapping into the CAN bus, and the ease of access varies between vehicles. Page 13 Automatic engine shutdown detection