Remove duplexer tray CAUTION When picking up the printer with the rear cover removed, do not lift by holding the duplexer tray. Whenever possible, handle the printer by holding the sides to prevent damaging internal components. Step 1 Remove the following assemblies: • Remove the toner cartridge. See “Toner cartridge removal and replacement” on page 96. • If installed, remove tray 3. See “Remove tray 3” on page 97. • Remove the cassette from tray 2. See “Remove the cassette from tray 2” on page 97. • Remove the DIMM cover. See “Remove DIMM cover” on page 99. • Remove the rear cover. See “Remove rear cover” on page 100. Step 2 Turn the printer over, top down.
Step 3 Unsnap the locking lever of the pivot pin, rotate it to the vertical position, and remove it from the mounting hole. Step 4 Pull the green duplexer release lever (callout 1) forward to release the duplexer tray. Step 5 Slightly raise the duplexer tray until the stop spring (callout 2) makes contact with the chassis. Push the spring in until it clears the slot in the chassis. Raise the door to the vertical position. Step 6 Raise the corner of the tray nearest the duplex media guide. Slide the tray toward the printer drive assembly. 21 2 Figure 90.
Duplexer tray Note When replacing the duplexer tray, verify that the stop spring (callout 2) correctly extends into the provided slot in the chassis. 120 Chapter 6 Removal and replacement C7058-90936