Table 29. Continuable attention error secondary codes (continued) 186 Chapter 7 Troubleshooting C7058-90936 Control-panel light pattern Continuable attention error secondary message Status log code Recommended action NVRAM error (68) 30035 or 30036 A memory error resulted in one or more printer settings being reset to factory defaults. Print a configuration page and verify that the printer setting are set correctly. Turn the printer off. Press and hold JOB CANCEL and turn the printer on. Keep JOB CANCEL depressed until all of the Control-panel lights illuminate. Release JOB CANCEL and send the print job again. Replace the formatter.
I/O error (81) The EIO accessory has encountered a critical error. Turn the printer off and then on. If the error message persists, turn the printer off and reset the EIO card. Turn the printer on. Replace the EIO card. Memory configuration error Perform a “cold reset”. Note If both the Attention and Ready lights come on before you release GO, then you must repeat the procedure. If the error persists, remove or replace DIMM(s). Replace the formatter. Personality or job-related error 30076 Perform a “cold reset”. Note If both the Attention and Ready lights come on before you release GO, then you must repeat the procedure.
If the error persists, remove or replace language DIMM. Replace the formatter.