REMINDER REMINDER • HDC automatically turns off when the vehicle speed exceeds 65 km/ h. • As long as the system detects rain drops or the wiper signal is ON, the brake disc will be regularly wiped at certain intervals to improve safety. • HDC works within the range of approximately 11-38 km/h. Within this range, the accelerator or brake pedal can be pressed or released to adjust vehicle speed. Cooperative Regenerative Braking System (CRBS) Controlled Deceleration for Parking Brake (CDP) The CRBS system combines motor energy regeneration torque and hydraulic braking torque to form the braking torque required by the driver.
When the driver presses the brake pedal, the motor energy regeneration torque and the hydraulic braking torque will continuously cooperate to meet any necessary braking requirements. When the EPB switch is pulled up, CDP will engage and the vehicle will brake at a constant deceleration (the deceleration will be 0.4g if only the EPB switch is pulled up and 0.8g if the EPB switch is pulled up and the brake pedal is pressed at the same time) until the vehicle comes to a stop. If EPB is released, CDP will stop functioning.
08 DRIVING Electronic Brake Pre-charging (EBP) Hill Hold Control (HHC) EBP will monitor the status of the accelerator pedal through the IPB system to pre-build pressure for the braking system, so as to shorten the response time of the braking system and improve driving safety. When the vehicle is started on a slope, HHC can maintain brake pressure for 1 second to prevent the vehicle from sliding backward after the brake pedal is released. WARNING! Roll Movement Intervention (RMI) • When the vehicle is started on a steep slope, the vehicle may slip. Therefore, never rely solely on HHC. Be mindful of safe driving.
When the vehicle turns, RMI will determine if there is a risk of rollover by monitoring the movement of the vehicle. If any risk is detected, braking will be applied to one or more wheels to decelerate and avoid rollover. Brake Disc Wiping (BDW) When the wiper switch is turned on or rain drops are detected by the rain sensors, IPB will apply a small brake pressure to the four brakes so the brake pads make contact with the discs. The water film on the brake discs is then removed to reduce the brake response time, and shorten the braking distance. Comfort Stop (CST) CST integrates the brake pedal adjustment and comfort stop functions to provide a more comfortable driving experience.
Brake pedal adjustment : the brake pedal mode is used to adjust how the driver feels the brake pedal on their foot. Changes in brake pedal pressing depth as a function of 115