BYD Tang — OWNER’S MANUAL - Archive.org

the instrument displays the "Scheduled Charging" countdown interface. 3. Power on the charging pile. 6. End charging. • Power on the charging pile according to its operation instructions. • Method 1: unplug the power plug. 4. Confirm connection: • Method 2: power off the charging pile according to its operation instructions. • The charging connector indicator in the instrument is on. 7. Double press the remote control key unlock button to unplug the charging connector. • The charging port indicator flashes green. 8. Reinsert the charging port protection 5. End charging. 9. Pick up the charging equipment and cover and close the hatch.

• Power off the charging pile according to its operation instructions. store it properly. 6. Double press the remote control key REMINDER unlock button to unplug the charging connector. • The charging connector can be connected before or after setting the scheduled charging time, but not after the scheduled time for charging to start. 7. Reinsert the charging port protection 8. Pick up the charging equipment and cover and close the hatch. store it properly. • The scheduled charging function cannot be used if SOC is below 15%. REMINDER • The method above is for general operation and may vary slightly according to the charging pile used. Follow the specific charging pile instructions.

DC Charging Charging in DC mode: 1. Open the charging port hatch and remove the two protection covers. Smart Charging In order to avoid power loss of the 12V battery (starter Fe battery), the smart charging function will activate and the power from the high-voltage battery is enabled to charge it when the following conditions are all met simultaneously: • The bonnet is closed. • The vehicle is powered off. • Battery is allowed to discharge. 2. Insert the charging connector. • 12V battery SOC is below stipulated limit. 146