BYD Tang — OWNER’S MANUAL - Archive.org

Rear Wiper Control OFF position In this position, the front wipers are off. MIST position When moving the switch to this position and holding, the front wipers will move slowly at a set frequency. Release the lever to stop the wipers. Moving the switch to this position and releasing it will make the front wipers stop after wiping once. Rotate the end knob of the wiper switch forward/backward to the corresponding position. The wiper motions will be: Washer Jets MIST Position Rotate the end knob of the wiper switch to this position and release. The knob will return to its original position and the rear windscreen washer jets will spray water once along with 4 times of wiping motions.

OFF Position In this position, the rear wiper is off. Pull up the wiper switch and hold. The front windscreen washer jets will spray water along with wiping motions. Release the switch to make the washer jets stop spraying, followed by 3 times of wiping motions. Another wiping motion follows a few seconds later. WIPER Position In this position, the rear wiper will work at a set frequency with the washer jets inactive. Washer Jet Position In this position, both the wiper and the washer jets are active. 96