Quick Guide Inserting the battery Open the LCD monitor and install the battery by inserting it in the direction shown in the Inserting/removing an SD card slot. Face the label side B in the direction shown in the illustration and press it straight in as far as it will go. Press the center of the SD card and then pull it straight out. 2) Press the C part of the SD card cover and close the SD card cover. A DC input terminal 1 Connect the AC cable to the AC adaptor, then the AC outlet. 2 Connect the AC adaptor to the DC input terminal. The status indicator will flash red at an interval of 2 seconds (approximately 1 second on, 1 second off), indicating that charging has begun.
It will turn off when the charging is completed. Securely close it until it clicks. 13 VQT4C76 figure. ≥Insert the battery until it clicks and locks. ∫ Charging the battery Access lamp [ACCESS] A ≥When this unit is accessing the SD card or built-in memory, the access lamp lights up. ≥Check that the access lamp has gone off. 1) Open the SD card cover and insert/ remove the SD card into/from the card