Recording Recording Motion Picture Applicable modes: This camera can record full high definition motion pictures compatible with the AVCHD format or motion pictures recorded in MP4. Audio will be recorded in stereo. 1 Start recording by pressing the motion picture button. A Elapsed recording time B Available recording time Recording of motion picture appropriate for each mode is possible. The recording state indicator (red) C will flash while recording motion pictures. If approximately 1 minute elapses without an operation being performed, part of the display will disappear. Press [DISP.] or touch the monitor to make the display reappear.
Release the motion picture button right after you press it. 2 Stop the recording by pressing the motion picture button again. Still picture recording is also possible during the motion picture recording by fully pressing the shutter button. B When a high ambient temperature, continuous recording or other conditions cause the camera to overheat, the following restrictions will occur to protect the camera. Wait until the camera cools down. Continuous recording, motion picture recording, and the Wi-Fi connection will be temporarily disabled. If you continue recording even when [ ] is flashing on the screen, a message will be displayed and the camera will turn off automatically.
It is recommended to use a fully charged battery or AC adaptor (DMW-AC10PP: optional) when recording motion pictures. If while recording motion pictures using the AC adaptor (DMW-AC10PP: optional) the power supply is cut off due to a power cut or if the AC adaptor (DMW-AC10PP: optional) is disconnected etc., the motion picture will not be recorded. Maximum time to record motion pictures continuously with [MP4] is 29 minutes 59 seconds or up to 4 GB. (For [FHD/28M/60p]/[FHD/20M/30p] in [MP4] format, the file size is large and so the recordable time will drop below 29 minutes 59 seconds.) (ENG) SQT0419 25 C 3s R1m37s