When the interchangeable lens (H-FS12032) is attached, extend the lens barrel before use. Set the drive mode to [ ] (single) by pressing 4 ( ). 1 Select the Recording Mode. (P21) 2 Press the shutter button halfway to focus. A Aperture value B Shutter speed Aperture value and shutter speed are displayed. (It will flash in red if the correct exposure is not achieved, except when set to flash.) When the image is correctly focused, the picture will be taken, since the [Focus/Release Priority] is set initially to [FOCUS]. 3 Press the shutter button fully (push it in further), and take the picture.
B A 60 60 60 3.5 3.5 3.5 This camera can record full high definition motion pictures compatible with the AVCHD format or motion pictures recorded in MP4. Audio will be recorded in stereo. 1 Start recording by pressing the motion picture button. A Elapsed recording time B Available recording time Recording of motion picture appropriate for each mode is possible. If approximately 1 minute elapses without an operation being performed, part of the display will disappear. Press [DISP.] or touch the monitor to make the display reappear. Release the motion picture button right after you press it. 2 Stop the recording by pressing the motion picture button again.
Maximum time to record motion pictures continuously with [MP4] is 29 minutes 59 seconds or up to 4 GB. (For [FHD/30p] in [MP4] format, the file size is large and so the recordable time will drop below 29 minutes 59 seconds.) When a high ambient temperature, continuous motion picture recording or other conditions are causing the camera to overheat, [ ] flashes. If a message is displayed after [ ] flashes, the camera will turn off automatically to protect itself. When this happens, some functions will be disabled until the camera cools down. Still picture recording is also possible during the motion picture recording by fully pressing the shutter button.
A 3 s 3 s 3 s R 1 m 37 37 s R 1 m 37 s B 20 VQT5D49 (ENG) Taking a Still picture Recording Motion Picture