“NO PLAY” There is no album or track in the USB device. Examine the content. You can only play supported format. The system may have a problem. Turn off the system and then turn on again. “PLAYERROR” You played an unsupported MP3 file. The system will skip that track and play the next one. “REMOTE 1” “REMOTE 2” The remote control and the main unit are using different codes. Change the code of the remote control. When “REMOTE 1” is shown, press and hold [OK] and [ ] on the remote control for a minimum of 4 seconds. When “REMOTE 2” is shown, press and hold [OK] and [USB/CD] for a minimum of 4 seconds. “USB OVER CURRENT ERROR” The USB device is drawing too much power.
Disconnect the USB device, turn off the system and then turn on again. Check the connection, it may be caused by a faulty USB cable. The system cannot show the remaining play time for variable bit rate (VBR) tracks. Remote control code When other Panasonic equipment responds to the remote control of this system, change the remote control code for this system. Preparation Press [USB/CD] to select “CD”. To set the code to “REMOTE 1 Press and hold [SELECTOR] on the main unit and [USB/CD] on the remote control until “REMOTE 2” is shown. 2 Press and hold [OK] and [USB/CD] for a minimum of 4 seconds.
To set the code to “REMOTE 1 Press and hold [SELECTOR] on the main unit and [ ] on the remote control until “REMOTE 1” is shown. 2 Press and hold [OK] and [ ] for a minimum of 4 seconds. TQBM0945 23