PanelScan Integration Guide Hardware Configuration and Wiring Trigger and power wiring must be completed as shown below. A single 24 VDC power source can be used to power all elements of the system. A terminal block is provided with the system to aid in the wiring of all components. The diagram below shows wiring for the Standard system. For the Wide system, cables 3 , 4 , 5 , and 6 are duplicated and should be wired in parallel to power ( 8 ), to the trigger ( 9 ), and to the PC NIC card. Note: Hardware configuration and wiring are the same for all Standard and Wide configurations. 5 Copyright © 2019 Omron Microscan Systems, Inc.