182 4-5 Driving Assistance Functions Precautions The PEB system cannot ensure zero collision. In complex traffic, the system cannot always clearly identify all the vehicles or pedestrians. It may trigger unnecessary warning or braking action for well covers, iron plates or road signs. Make sure to drive safely and observe surrounding traffic conditions. The AEB is not a substitute for normal braking operation in any event. Do not overly rely on the PEB system as this may result in serious accidents leading to severe injuries or deaths. The system is only an auxiliary safety tool.
The driver must always keep a safe distance from vehicles ahead, control the speed, and be ready to brake or steer away when necessary. The driver must keep control of vehicle at all times and be fully responsible for safe driving. The AEB system is activated only when it exceeds certain speeds. Careful driving is always required, because the system may not be triggered correctly. When the ESC function is disabled or the trouble light is on, the AEB system cannot work normally. If PCW gives an alarm, the driver must brake based on traffic conditions to decrease vehicle speed or steer away from obstacles.
If the vehicle travels too close to the vehicle ahead for too long, a safety distance warning will be given. If the vehicle ahead brakes suddenly, collision may be unavoidable. The system will not trigger AEB when the driver is aware of an emergency warning, but turns the steering wheel, depress the throttle pedal hard or brakes hard. The radar sensor may have a transient function failure from limited detection if the vehicle runs under special conditions, such as circular ramps or tunnels. The function may be recovered by restarting the vehicle or driving under normal conditions for a while.
When radar or camera surface is dirty or covered with foreign materials, a message is displayed on the instrument cluster (Radar or camera sensor may become blind if its surface is dirty or covered with