278 6-3 Self-Maintenance Tire treads are cast with wear marks. When the tread is worn at this point, tread thickness is less than 1.6 mm. The adhesion of tires worn to this extent is very small on wet roads. When the tread is worn to the point where the wear mark is exposed, there is serious performance loss, and the tires should be replaced. Maintenance In addition to proper inflation, proper wheel alignment also helps reduce tread wear. If uneven tire wear is found, go to a BYD authorized dealer or service provider and check the wheel alignment. The vehicle has been balanced in the factory, but tires need to be re-balanced after driving for a period of time.
If there is some kind of continuous vibration while driving at high speeds (above 80 km/h), but not at low speeds, go to a BYD authorized dealer or service provider and check the tires. If a tire has been repaired, be sure to re-balance it. When installing a new tire or replacing a new wheel, always perform tire balancing. Note Improper wheel balancers will get stuck, become loose and fall off. While driving, this will damage the car or surrounding objects. Improper wheel balancers will damage the aluminum rims of the vehicle. Therefore, it is recommended to use original wheel balancers.
Tire Rotation In order to make tires wear the same and prolong their service life, it is recommended to rotate tires regularly and conduct four-wheel alignment, inspection and adjustment as well.