Super Micro Computer, Inc. PDSMA+ / PDSMA-E+ — Super Micro PDSMA+ / PDSMA-E+ User Manual: Motherboard Guide PDF

PDSMA+/PDSMA-E+ User’s Manual 1-3 Special Features Recovery from AC Power Loss BIOS provides a setting for you to determine how the system will respond when AC power is lost and then restored to the system. You can choose for the system to remain Powered Off (in which case you must hit the power switch to turn it back on when the power is restored.) You can also select "Last State" from the Advanced BIOS Setup section. In this case, the system will be restored to its original state before the power outage. The default setting is Last State. 1-4 PC Health Monitoring This section describes the PC health monitoring features of the PDSMA+/PDS- MA-E+.

The motherboard has an onboard System Hardware Monitor chip that supports PC health monitoring. Onboard Voltage Monitors for the CPU Cores, Chipset Voltage (+1.5V), Memory Voltage (+1.8V), +3.3V, +3.3V Standby, +5V, + 5V Standby, + 12V, 12V, VTT FSB and VBAT. The onboard voltage monitor will scan these voltages continuously. Once a voltage becomes unstable, it will give a warning or send an error message to the screen. The user can adjust the voltage thresholds to define the sensitivity of the voltage monitor. The PC health monitor can check the RPM status of the cooling fans. The onboard fans are controlled by Thermal Management via BIOS.

Fan Status Monitor with Firmware Speed Control CPU Overheat/Fan Fail LED and Control This feature is available when the user enables the CPU overheat warning option in the BIOS. This allows the user to define an overheat temperature. When this temperature reaches the threshold, the CPU thermal trip feature will be activated and it will send a signal to the Speaker LED and, at the same time, the CPU speed will decrease. It will also activate the alarm if a fan failure occurs. 1-10