Chapter 2: Installation Connect an LED cable to the OH/Fan Fail connection on pins 7 and 8 of JF1 to provide an advanced warning of chassis overheating or system fan failure. Refer to the table on the right for pin definitions. Overheat/FanFail LED Reset Button The Reset Button connection is lo- cated on pins 3 and 4 of JF1. Attach it to the hardware reset switch on the computer case. Refer to the table on the right for pin definitions. A. OH/Fan Fail LED B.
Reset LED USB 1/2 KB/MS Ground 19 20 COM1 X VGA JLAN1 Power LED JLAN2 NIC1 LED NIC2 LED S A+/PDSMA-E+ M S D P R E P U LAN1 Fan5 OH/Fan Fail LED CTRL LAN2 HDD LED S I/O CTRL Ground X Reset Button B ® SATA1 SATA3 Power Button COM2 Floppy J9 WOL JL1 2-11 2 1 OH/Fan Fail Indicator Status State Definition Off Normal On Overheat Flash- ing Fan Fail OH/Fan Fail LED Pin Definitions (JF1) Pin# Definition 7 Vcc 8 Ground Reset Button Pin Definitions (JF1) Pin# Definition 3 Reset 4 Ground 3 4PW PW 8 JPR1 -pin PWR 2 R PW ATX 4-Pin OH/ A VGA CTRL DIMM 2B DIMM 1B Fan1 DIMM 1A BIOS 1 *Compact Flash only n4 Primary IDE nd nd N X Vc Vc Vc Vc Vc Vc Reset PWR