PDSMA+/PDSMA-E+ User's Manual Power Fault (PWR Supply Failure) Connect a cable from your power supply to the Power Fail (PSF) header (PW3) to provide a warning of power supply failure. This warning signal is passed through the PWR_LED pin to indicate of a power failure on the chassis. See the table on the right for pin definitions. Note: This feature is only available when using Supermicro redundant power supplies. Alarm Reset If three power supplies are installed and Alarm Reset (JPR1) is enabled, the system will notify you when any of the three power modules fails. Con- nect JPR1 to a micro-switch to turn off the alarm that is activated when a power module fails.
See the table on the right for pin definitions. USB 1/2 KB/MS COM1 A. Power Fault B. Alarm Reset VGA JLAN1 JLAN2 S A+/PDSMA-E+ M S D P R E P U ® COM2 Floppy J9 WOL JL1 SATA1 SATA3 2-20 PWR Supply Fail LED Pin Definitions Pin# Definition 1 PWR 1: Fail 2 PWR 2: Fail 3 PWR 3: Fail 4 Signal: Alarm Reset Alarm Reset Pin Setting Definition Pin 1 Ground Pin 2 +5V A B 8-pin PWR VGA DIMM 2B PW 4PW 3 JPR1 PWR ATX 24-Pin CTRL DIMM 1B Fan1 DIMM 2A JPG1 (CPUFan) DIMM 1A Fan6 Intel 3000 CPU IntelO 3R 010 Fan2 LGA 775 North Bridge CTRL JLED Fan3 Fan5 FP PCI-Exp.
x8 JWD LAN1 PCI-X 64-bit 133 MHz JPF 2.0 CTRL JJII22CC21 IPMI PCI 32-bit 33 MHz PXH-V LAN2 PCI 32-bit 33 MHz CTRL JJPPLL12 PCI 32-bit 33 MHz BIOS LL EE 34 ICH7R I/O PCI 32-bit 33 MHz *CompacJ t W Fl F a1 sh only Primary IDE Printer South Bridge Battery PCI 32-bit 33 MHz JBT1 SPKRUSB5/6USB3/4JP3 SATA0SATA2 LE1 n4 4 PW 3 PW JPR1 8-pin PWR 2 R PW ATX 4-Pin DIMM 2B DIMM 1B Fan1 BIOS 1 *Compact Flash only n4 Primary IDE