PDSMA+/PDSMA-E+ User's Manual 2-9 Floppy, Hard Disk Drive, IPMI and Printer Connections Note the following when connecting the floppy and hard disk drive cables: The floppy disk drive cable has seven twisted wires. A red mark on a wire typically designates the location of pin 1. A single floppy disk drive ribbon cable has two connectors to provide for two floppy disk drives. The connector with twisted wires always connects to drive A, and the connector that does not have twisted wires always connects to drive B. Floppy Connector The floppy connector is located between the IDE connectors and the printer. See the table below for pin definitions.
USB 1/2 KB/MS CTRL VGA PW3 PW4 JPR1 8-pin PWR 24-Pin ATX PWR COM1 JPG1 (CPUFan) Fan6 DIMM 1A VGA JLAN1 North Bridge CPU Intel 3010 OR Intel 3000 Fan2 A. Floppy JLAN2 LGA 775 L R T C P F LAN1 Fan5 PCI-Exp.
x8 JPF JWD IPMI 2.0 JLED Fan3 S A+/PDSMA-E+ M S D P R E P U CTRL PCI-X 64-bit 133 MHz PCI 32-bit 33 MHz JI2C1 JI2C2 PXH-V LAN2 CTRL JPL1 JPL2 PCI 32-bit 33 MHz PCI 32-bit 33 MHz ® S I/O PCI 32-bit 33 MHz Printer L E 3 L E 4 South Bridge ICH7R COM2 A Floppy PCI 32-bit 33 MHz J9 WOL SPKR JBT1 USB3/4 USB5/6 JP3 JWOR JL1 LE1 SATA0 SATA1 SATA3 2-28 Floppy Drive Connector Pin Definitions Pin# Definition Pin # Definition 1 Ground 2 FDHDIN 3 Ground 4 Reserved 5 Key 6 FDEDIN 7 Ground 8 Index 9 Ground 10 Motor Enable 11 Ground 12 Drive Select B 13 Ground 14 Drive Select B 15 Ground 16 Motor Enable 17 Ground 18 DIR 19 Ground 20 STEP 21 Ground 22 Write Data 23 Ground 24 Write Gate 25 Ground 26 Track 00 27 Ground 28 Write Protect 29 Ground 30 Read Data 31 Ground 32 Side 1 Select DIMM 2B DIMM 1B Fan1 BIOS 1 *Compact Flash only n4 Primary IDE