Appendix D: Adaptec HostRAID Setup Guidelines Configuring Disk Drives You may need to configure a disk drive before you can use it. Caution: Configuring a disk may overwrite the partition table on the disk and may make any data on the disk inaccessible. If the drive is used in an array, you may not be able to use the array again. Note: Do not configure a disk that is part of a boot array. To determine which disks are associated with a particular array, please refer to the section: Viewing Array Properties. To configure a disk drive: 1. From the main menu (shown on Page D-4), select Configure Drives and hit Enter > (as shown below.) D-5