Super Micro Computer, Inc. E7230 — Super Micro E7230 Motherboard User's Manual PDF: PDSMi Guide for Integrators & Technicians

PDSMi User's Manual 2-9 Floppy, Hard Disk Drive, IPMI and Printer Connections Note the following when connecting the fl oppy and hard disk drive cables: • The fl oppy disk drive cable has seven twisted wires. • A red mark on a wire typically designates the location of pin 1. • A single fl oppy disk drive ribbon cable has two connectors to provide for two fl oppy disk drives. The connector with twisted wires always connects to drive A, and the connector that does not have twisted wires always connects to drive B. Floppy Connector The fl oppy connector is located between the IDE connectors and the printer. See the table below for pin defi nitions. A.

Floppy KB/MS J28 24-Pin ATX PWR JPW1 Fan6/CPU Fan 8-pin PWR Fan1 JPW2 USB 1/2 J15 COM1 Pentium Dual Core CPU VGA J31 Mukilteo E7230 LGA 775 JG1 (North Bridge) GLAN1 DIMM 1A DIMM 1 DIMM 2A DIMM 2 JLED GLAN2 Fan5 DIMM 1B DIMM 2B DIMM 3 DIMM 4 FP CTRL LAN SXB -E1 PCI-Ex8 Slot6 PCI-X 133 MHz JF1 Fan3 Fan2 CTRL JI 2 C1 2 JWD S UPER PDSMi REV 1.0 LAN CTRL JPL1 JPL2 ® S I/O J30 Printer A 2-24 Floppy Drive Connector Pin Defi nitions Pin# Defi nition Pin # Defi nition 1 Ground 2 FDHDIN 3 Ground 4 Reserved 5 Key 6 FDEDIN 7 Ground 8 Index 9 Ground 10 Motor Enable 11 Ground 12 Drive Select B 13 Ground 14 Drive Select B 15 Ground 16 Motor Enable 17 Ground 18 DIR 19 Ground 20 STEP 21 Ground 22 Write Data 23 Ground 24 Write Gate 25 Ground 26 Track 00 27 Ground 28 Write Protect 29 Ground 30 Read Data 31 Ground 32 Side 1 Select 33 Ground 34 Diskette JI C2 Battery J PXH-V VGA IPMI CTRL Buzzer L E 3 ICH7R L E 4 (South Bridge) G1 COM2 J9 ot1PCI 32 Bit/33 MHz JBT1 JWOR USB3/4 USB5/6 E1 JW F1 SATA3 SATA2 SATA1 SATA0 P3 G1 COM2 ot1PCI 32 Bit/33 MHz J27 Floppy J4 IDE (*Compact Flash Card only) JL1 L J J3 IDE (Primary) Fan4