Super Micro Computer, Inc. E7230 — Super Micro E7230 Motherboard User's Manual PDF: PDSMi Guide for Integrators & Technicians

Appendix A: BIOS POST Messages System CMOS checksum bad - Default confi guration used System CMOS has been corrupted or modifi ed incorrectly, perhaps by an application program that changes data stored in CMOS. The BIOS installed Default Setup Values. If you do not want these values, enter Setup and enter your own values. If the error persists, check the system battery or contact your dealer. System timer error The timer test failed. Requires repair of system board. Real-Time Clock fails BIOS hardware test. May require board repair. Real time clock error Check date and time settings BIOS found date or time out of range and reset the Real-Time Clock. May require setting legal date (1991-2099).

Previous boot incomplete - Default confi guration used Previous POST did not complete successfully. POST loads default values and offers to run Setup. If the failure was caused by incorrect values and they are not corrected, the next boot will likely fail. On systems with control of wait states , improper Setup settings can also terminate POST and cause this error on the next boot. Run Setup and verify that the waitstate confi guration is correct. This error is cleared the next time the system is booted. Memory Size found by POST differed from CMOS Memory size found by POST differed from CMOS. Diskette drive A error Diskette drive B error Drive A: or B:

is present but fails the BIOS POST diskette tests. Check to see that the drive is defi ned with the proper diskette type in Setup and that the diskette drive is attached correctly. Incorrect Drive A type - run SETUP Type of fl oppy drive A: not correctly identifi ed in Setup. Incorrect Drive B type - run SETUP Type of fl oppy drive B: not correctly identifi ed in Setup. A-3