Super Micro Computer, Inc. E7230 — Super Micro E7230 Motherboard User's Manual PDF: PDSMi Guide for Integrators & Technicians

Appendix B: BIOS POST Codes Appendix B BIOS POST Codes This section lists the POST (Power On Self Test) codes for the PhoenixBIOS. POST codes are divided into two categories: recoverable and terminal. Recoverable POST Errors When a recoverable type of error occurs during POST, the BIOS will display an POST code that describes the problem. BIOS may also issue one of the follow- ing beep codes: 1 long and two short beeps - video confi guration error 1 continuous long beep - overheat (Overheat LED will be on) 1 long beep and 1 short pause - memory not detected Terminal POST Errors If a terminal type of error occurs, BIOS will shut down the system.

Before doing so, in the top left corner of the screen. BIOS will write the error to port 80h, attempt to initialize video and write the error The following is a list of codes that may be written to port 80h. POST Code Description 02h Verify Real Mode 03h Disable Non-Maskable Interrupt (NMI) 04h Get CPU type 06h Initialize system hardware 07h Disable shadow and execute code from the ROM.

08h Initialize chipset with initial POST values 09h Set IN POST fl ag 0Ah Initialize CPU registers 0Bh Enable CPU cache 0Ch Initialize caches to initial POST values 0Eh Initialize I/O component 0Fh Initialize the local bus IDE 10h Initialize Power Management 11h Load alternate registers with initial POST values 12h Restore CPU control word during warm boot 13h Initialize PCI Bus Mastering devices 14h Initialize keyboard controller 16h 1-2-2-3 BIOS ROM checksum 17h Initialize cache before memory Auto size B-1