Appendix C: Software Installation Appendix C Software Installation SATA RAID* before you install the Windows Operating System and other software drivers. After all the hardware has been installed, you must fi rst confi gure Intel's ICH7R Important Notes to the User: *Note 1: If you do not wish to confi gure onboard SATA RAID functions, please go directly to Section C-4 for Operating System & Other Software Installation. *Note 2: This chapter describes RAID Confi guration Instructions for the Intel ICH RAID Controller designed for the Windows OS. If you choose to use the Linux OS, please enable Adaptec's RAID Controller in the BIOS and refer to the fi le:
motherboard for Adaptec RAID Confi guration Instructions. C-1 Introduction to Serial ATA and Parallel ATA "E7230 Note.txt" in the folder: "Intel E7230" saved in the CD that came with your To confi gure the SATA RAID functions, you must fi rst use the Intel ICH7R SATA RAID Utility program to confi gure the RAID Level that you desire before installing the Windows XP/2000/2003 operating system and other software drivers. (The necessary drivers are all included on the Supermicro CD that came packaged with your motherboard.) Note that the current version of the ICH7R SATA RAID Utility can only support the Windows XP/2000/2003 Operating Systems.
Serial ATA (SATA) Serial ATA (SATA) is a physical storage interface that uses a single cable with a a serial link, which supports transfer rates up to 3Gbps. Because the serial cables minimum of four wires to create a point-to-point connection between devices. It is used in SATA are thinner than the traditional cables used in Parallel ATA (PATA), SATA systems have better airfl ow and can be installed in smaller chassis than Parallel ATA. In addition, the cables used in PATA are limited to a length of 40cm, while Serial ATA cables can be up to one meter in length. Overall, SATA provides better functionality than PATA.
Introduction to Intel ICH7R Serial RAID Located in the South Bridge of the E7230 Mukilteo chipset, the I/O Controller Hub ports a 2-channel UltraATA/100 Bus Master IDE controller (PATA) and four Serial (ICH7R) provides the I/O subsystem with access to the rest of the system. It sup- ATA (SATA) ports. The ICH7R supports the following PATA and SATA device con- fi gurations: Legacy mode and Native mode. C-1