Troubleshooting file:///D|/My%20Documents/dfu/190X7/english/190x7/safety/saf_troub.htm (1 of 3)2006-12-06 2:44:03 PM • Safety and Troubleshooting • FAQs • Common Problems • Imaging Problems • Regulatory Information • Other Related Information Troubleshooting This page deals with problems that can be corrected by the user. If the problem still persists after you have tried these solutions, contact your nearest Philips dealer. Common Problems Having this problem Check these items Make sure the power cord is plugged into G the power outlet and into the back of the monitor.
No Picture First, ensure that the power button on the G (Power LED not lit) front of the monitor is in the OFF position, then press it to the ON position. Make sure the computer is turned on. G Make sure the signal cable is properly G No Picture connected to your computer. Check to see if the monitor cable has bent G (Power LED is amber or yellow) pins. The Energy Saving feature may be G activated Screen says G Make sure the monitor cable is properly connected to your computer. (Also refer to the Quick Set-Up Guide). Check to see if the monitor cable has bent G pins. Make sure the computer is turned on.
G Screen says Make sure the vertical sync of input signal G is within the range of 56 ~ 75 Hz. Change the refresh rate to 56~75Hz within G 10 minutes. Re-power on monitor to start over again if G you failed to change the refresh rate within 10 minutes. Common Problems Having this problem Check these items Make sure the power cord is plugged into G the power outlet and into the back of the monitor. No Picture First, ensure that the power button on the G (Power LED not lit) front of the monitor is in the OFF position, then press it to the ON position. Make sure the computer is turned on. G Make sure the signal cable is properly G No Picture connected to your computer.
Check to see if the monitor cable has bent G (Power LED is amber or yellow) pins. The Energy Saving feature may be G activated Screen says G Make sure the monitor cable is properly connected to your computer. (Also refer to the Quick Set-Up Guide). Check to see if the monitor cable has bent G pins. Make sure the computer is turned on. G Screen says Make sure the vertical sync of input signal G is within the range of 56 ~ 75 Hz. Change the refresh rate to 56~75Hz within G 10 minutes. Re-power on monitor to start over again if G you failed to change the refresh rate within 10 minutes.