Switching on and initial setup Select [ Picture A] or [ Picture B] by pressing Н / Ж that is the most pleasing to you, then press OK . You see 5 different pictures to be completed. Before you switch on the TV, check that the AC power cord is properly connected. Press . POWER at the right side of the TV, or press . (standby-On) on the remote control. The TV normally takes 25-30 seconds to start up and the following screen appears the fi rst time you turn on the TV. English Which side of the picture do you prefer? Cancel Picture A Picture A Picture B Press Н / Ж to select [ Store] , then press OK .
After you read a welcome screen, follow the on-screen instructions to select your language and complete your TV setup. Installation takes approximately 20 minutes. Store your preferences. Cancel Store Press OK to fi nish [ Settings assistant] . The TV has learned your preferences. Exit Press Н / Ж to select [ Finish] , then press OK . Finish the Setup. Note If you are not receiving a signal from your cable service, contact the CATV provider. If you press . during autoprogram, an installation will be canceled except the language selection. The initial autoprogram function can be executed for either [Antenna] or [Cable] only once.
When you change the connection (Antenna / Cable), set autoprogram again. (Refer to page 34.) Press О / п to select the desired mode for energy saving, then press OK . Select [Retail store] if you want backlight to be brighter. Select [Home] to reduce power consumption. You must set [Home] . Otherwise, personalized picture and sound settings will not be memorized after the unit goes to standby mode. Select [Retail store] , the unit will be set up with predefi ned setting for retail displays. In this setting, the power consumption may possibly exceed the limited requirement of the ENERGY STAR ® qualifi cation. Select [Home] , the unit will be set to maximize energy effi ciency.
Picture and sound settings can be adjusted and saved as per your personal preferences. Press Н / Ж to select [ Start] , then press OK to begin [ Settings assistant] . Settings assistant will allow you to customize your picture settings to your personal preference. You will see a series of test pictures where the right side and left side differ. Select the side that is most pleasing to you with the Left/Right buttons. Cancel Start EN 11 ● Select your menu English language with the Up/Down buttons on ● Français your remote control, press the OK button to ● Español proceed. Location Home is recommended Retail store for normal home use. In the Retail Store location all settings Home are fixed.