3.26 TYPE (Tire Reset) This function can set the parameters of the size of the modified or replaced tire. 3.27 WINDOWS (Windows Calibration) This feature can perform door window matching to recover ECU initial memory, and recover the automatic ascending and descending function of power window. 3.28 LANGUAGE (Language Change) This function can change the system language of the vehicle central control panel. 3.29 AC System Relearn/Initialization If the ECU or actuator of the vehicle air conditioner is replaced, or the memory of the ECU memory is lost, air conditioner initialization learning is needed.
3.30 Engine Power Balance Monitoring At the power stroke of each cylinder, power balance monitors crankshaft acceleration, thus determining the relative power provided by each cylinder. 3.31 Gas Particulate Filter Regeneration After long-term use of the particle catcher, fuel consumption can be increased, engine output power can be decreased, then in this case, the GPF needs to be replaced or regenerated. 3.32 High Voltage Battery Diagnostics For diagnosis and state information detection on high-voltage accumulator. 3.33 Intelligent Cruise Control System For replacement of intelligent cruise control system of vehicle and matching after repairing.
3.34 Motor Angle Calibration There is a deviation between the rotor position detected by the angle position sensor of the motor and the actual rotor magnetic field position, so it is necessary to calibrate the motor angle. 3.35 IMMO PROG (Optional) Anti-theft editor supports vehicle key chip read and write, EEPROM chip read and write, MCU chip read and write, engine ECU and transmission ECU EEPROM and FLASH read and write. 30