3.16 EGR Adaption This function can learn the EGR (Exhaust Gas Recirculation) valve after it is cleaned or replaced. EN 3.17 ODO Reset This function can copy, write, or rewrite the value of kilometers in the chip of odometer, so that the odometer shows the actual mileage. It needs to be performed in the following cases: • When the mileage is not correct due to the damaged vehicle speed sensor or the odometer failure. 3.18 Airbag Reset This function resets the airbag data to clear the airbag collision fault indicator, so that the airbag computer in the vehicle can run normally. It needs to be performed in the following cases:
• When the vehicle collides and the airbag deploys, the corresponding fault code of the collision data appears, the airbag indicator lights up, and the fault code cannot be cleared. 3.19 Transport Mode This function can deactivate the transport mode, so that the vehicle can function normally. It needs to be performed in the following cases: • When the following functions disabled including limiting the vehicle speed, not waking up the door opening network, and disabling the remote control key, etc. in order to reduce the power consumption. 3.20 A/F Reset 3.21 Stop/Start Reset This function can set or learn Air/Fuel ratio parameters.
This function can open or close the automatic start-stop function via setting the hidden function in ECU (provided that the vehicle has a corresponding hidden function supported by hardware). 3.22 NOx Sensor Reset This function can reset the catalytic converter learned value stored in the engine ECU. It needs to be performed in the following cases: • When the NOx fault is re-initialized and the NOx catalytic converter is replaced. 31