HP-335 Nov. 1998 STAND ASSEMBLY (KS-305) 2. Installing the Piano on the Stand Make sure that another person is on hand to help with the assembly and setup. (4) Align the protruding screws (one each at right and left) on the bottom of the piano with the openings in the metal fittings on the side board, then slide the piano forward until To move the piano, lift it carefully—all the while keeping it level. Be very careful, when you assemble and move the piano, to make sure that you do not drop it on your hands or feet. the screws are held in place. G Part Check (5) Fasten the piano to the stand with the screw “d” (M5 X 20 mm) (one each for the right and left).
Before you begin assembling the stand, check that all the parts were supplied. You will also need to have a Phillips screwdriver. (4) A : Side Board ( left ) 1 : Screw a ( 4 Ч 16 mm ) Ч 4 B : Side Board ( right ) 2 : Screw b ( 4 Ч 25 mm ) Ч 4 C : Pedal Board 3 : Screw c ( M6 Ч 70 mm ) Ч 4 Please don't get your fingers pinched (5) D : Rear Board 4 : Screw d (M5 Ч 20 mm ) Ч 2 5 : Cap Ч 4 Screw d 1 a * When handling the piano, firmly grasp it at the front and back. Be careful, so you do not get your fingers pinched. D B 3 2 b c 4 d 3. Connecting the Pedal and Power Cords A C 5 (6) Connect the pedal cord to the Pedal jack on the rear of the piano.
G Assembly Procedure * Fasten each screw tightly, then place the stand in a stable and horizontal place. * Do not allow the pedal cord or power cable to get twisted or pinched while assembling the stand. (7) Connect the power cord to the power inlet on the piano, then plug the other end into a wall socket. 1. Stand Assembly (1) Attach the side boards for the right and left sides to the pedal board (so that the metal parts face inside) using screws “c” (M6 Ч 70 mm). (6) (2) Place the rear board as shown below, with the wood grain side facing inside. (7) (3) Attach the rear board to the metal parts on the side boards from the front using screws “a” (4 Ч 16 mm).
For clamping the rear board, press each upper portion of both side boards. Then, fasten it to the pedal board from the back using screws “b” (4 Ч 25 mm) and attach the caps on screw “c.” 4. Adjusting the Adjuster (8) Lower the adjuster at the bottom of the pedal board (by rotating it), so that the pedal board touches the floor. If you Screw c have the piano placed on a carpet, lower it until it pushes into the carpet. (1) Wood grain side (2) Cap Screw b Screw a Adjuster (8) * At first, assemble the entire stand in a temporary fashion, without really tightening the screws.
Then, after checking the overall alignment of the boards (and gently shifting certain parts where necessary), go around and tightly fasten each of the screws. (3) When Moving the Piano Disconnect the power cord and raise the stand’s adjuster. Then lift the piano while keeping it level, and move it with care, so that you do not drop it on your feet, or get your hands caught. 9