HP-535 Nov. 1998 STAND ASSEMBLY (KS-505) 2. Fixing the Pedal Board and Side Boards Ў Position the Pedal Board so it rests on top of the metal fitting at the bottom of the Side Board q . 1. Part Check Before you begin assembling the stand, check that all the parts were supplied. You will also need to have a Phillips screwdriver. A C Ў Move the Pedal Board so it is in close contact with the Side Board w , then while shifting it forward or backward as necessary e , push it down until it has been grasped firmly by the metal fitting r . B D A : Side Board ( left ) B : Side Board ( right ) C : Pedal Board D :
Rear Board Screw a ( 4 x 20 mm ) x 8 Screw b ( 4 x 25 mm ) x 4 Screw c ( M5 x 20 mm ) x 2 CAUTION Ў Push the Pedal Board in the direction of the arrow t , then fasten it with screws “a” y . • Make sure that another person is on hand to help with the assembly and setup. • When assembling the piano stand, do not apply excessive pressure on any part. To do so can cause metal parts to get bent out of shape, and may damage wooden parts. • Be very careful, when you assemble and move the piano, to make sure that you do not drop it on your hands or feet. • To move the piano, lift it carefully—all the while keeping it level.
• Fasten each screw tightly, then place the stand in a stable and horizontal place. • Do not allow the pedal cord or power cable to get twisted or pinched while assembling the stand. • At first, assemble the entire stand in a temporary fashion, without really tightening the screws. Then, after checking the overall alignment of the boards (and gently shifting certain parts where necessary), go around and tightly fasten each of the screws. Screw a Ў In the same manner, fasten the other side with screws “a” u . Pedal Cord Screw a 12